Slab Leak Repair in San Antonio, TX
We locate buried water-line leaks beneath San Antonio slabs and plan the repair route.
Older homes in San Antonio, Olmos Park, Terrell Hills, and Alamo Heights need a slab-leak check from us when aging copper water lines run beneath a concrete foundation, because pipe-wall wear and soil movement can open a leak out of sight.
Water from a buried line may follow soil or a slab edge before it shows at a baseboard, and we trace the source rather than assume the wet area is above the pipe. A hidden hot-water leak can also keep a water heater cycling as heat is lost into the slab.
Suspected slab leaks should not wait because escaping water can saturate soil beneath the foundation, damage flooring and wall materials, and make the repair route more involved.
Warm floor and moving meter
A warm floor patch near a bathroom or water heater can point to a hot-water line leaking below the slab. We also check a water meter that continues moving after faucets, ice makers, and irrigation are off.
Damp carpet, a dark baseboard line, or a musty odor can result when water reaches flooring or wall materials from below. Low pressure at several fixtures can accompany a supply-line loss, although a valve or another plumbing leak can cause that symptom.
Those clues do not identify one fault or one repair route, so we test the lines before deciding what needs to be opened or replaced. A moving meter, a warm tile, and a damp wall can each lead to different work and different costs.
Pressure test and pipe locating
During a pressure test and pipe-locating visit, we read the water meter, isolate hot and cold lines where the plumbing layout allows, and inspect the foundation perimeter, water-heater connections, and visible valves. We record gauge pressure and watch it for 15 to 30 minutes after fixtures are shut off.
After isolation narrows the line, we use acoustic listening equipment and, on a hot-water line, a thermal camera to locate the likely path without opening the whole floor. Residential supply pressure commonly falls within 40 to 80 psi, but we compare pressure changes rather than relying on one reading.
The meter check, pressure test, and location work are completed during the inspection visit. We plan saw cutting, tunneling, pipe rerouting, or flooring removal separately when the pipe depth or access route requires it.
Pipe depth and access route
Pipe depth, access route, and line material are factors we assess before setting the repair scope. A leak reached through an exterior route or a targeted opening can involve less interior restoration than a line beneath tile, cabinets, or a finished room.
An older shutoff valve that will not close adds isolation work for us, while a damaged section may require matching copper or a different reroute material. Ordered fittings, permit review, or required sign-off can add steps when the repair changes a water-line route or opens a structural area.
We identify these conditions before choosing a repair route because access through soil, concrete, or finished flooring changes the labor and restoration involved.
Meter reading and heater plate
The water-meter reading, including whether its leak indicator moves while every fixture is off, gives us a useful starting point. We also need the room above the suspected line, the fixture nearest the warm or damp area, and whether water is actively appearing at a floor edge.
A water-heater rating plate is useful when the suspected line carries hot water, and we can use the model and serial number printed on the tank or unit to identify connected equipment. Photographs of the access area, crawlspace opening, or exterior wall help us understand the route before arriving.
Tell us whether an interior shutoff operates and whether furniture, tile, cabinets, or landscaping blocks the likely access path. Call Plumbing Solutions San Antonio at (726) 227-4061 before escaping water washes more soil from beneath the slab.
Next: get in touch, or back to the home page.